Top up rear brake fluid reservoir

Before carrying out the work make sure you are confident you know what you are doing... If
you have any questions feel free to ask them on our discussion forum. Remember if you don't feel
confident about what you are doing take the bike to a qualified mechanic.

	Unlock the helmet lock and push the lever to release the seat. Remove the seat.
	Undo the allen bolt securing the rear cowlings and pop the two fastners. The cowling should move and expose the brake fluid cylinder.
	Check the level of fluid from the side with the bike upright, if the fluid is below the middle of the two marks add more to top up by removing the two screws holding the lid on the cylinder.
	With the lid off pour in more DOT 4 fluid. Make sure no dirt gets in the cylinder.
	Replace the lid and tighten the two screws.
	Snap the cowling back into place and secure the allen bolt.
	Replace the seat.